1 - Phillips head screws 4 Nm; 2 - Disc. In need of replacement replace both rear brake discs. Before removing the brake disc caliper must be removed; 3 - a protective cap. When installing, use a new cap; 4 - Self-locking nut dvenadtsatigrannaya 175 Nm. When you install a new nut should be used; 5 - wheel hub bearing; 6 - a bolt, 60 Nm. The bolt should be installed with a plate spring washer; 7 - partition; 8 - pin hub; | 9 - a cable of a manual brake; 10 - rear beam; 11 - sensor ABS; 12 - Allen screw; 13 - a bolt with hexagon 65 Nm; 14 - the holder of a support; 15 - the brake hose. Brake Hose attached hollow screw with seals. Tightening the screws to 35 Nm is produced; 16 - self-locking bolt, 35 Nm. When installing, use a new bolt; 17 - Caliper; 18 - the brake pads; 19 - the clips |