Removal, service and installation of the hub and bearings (front wheel)
Assembling the hub bearing and related components
This procedure applies only to models of 4WD. On nepolnoprivodnyh models use sealed bearings type.
Hub bearing unit can not be disassembled. In case of damage or deterioration of the hub bearing must be replaced or the entire assembly.
- Sandpaper smooth out the hole in the knuckle by removing from it all traces of rust and dirt. Lubricate the splines of the drive and lubricate wheel bearings. Use the same grease for the lubrication holes in the walls of the knuckle and install the hub assembly into place. Tighten the hub to knuckle with demanded effort.
- Replace the washer and nut hub, tighten the nut. Insert the disc and brake caliper (Chapter Brake System) and push the wheel and lower the car to the ground. Tighten the wheel nuts with demanded effort (Head of Adjustment and routine maintenance).
- Tighten the hub nut to the required torque, the slider, and a new cotter pin. Put the hub cap.