| Home |
| | | Kia |  | Sportage | | Introduction | | Controls and operation receptions | | Current care and maintenance | | Engine | | System of cooling, heating, ventilation and air conditioning | | general information | | Engine cooling system | | | Ventilation systems, heating and air conditioning | | | General information and safety measures | | | Troubleshooting, check the system components K / | | | Removal and installation of assemblage blower / evaporator service components | | | Removal and installation of the heater assembly, maintenance components | | | Removal and installation of communication lines refrigerator path of K / | | | Removal, check and installation of compressor K / V | | | Removal, check and installation of the fan of the condenser K / V | | | Removal, check and installation of the condenser K / V | | |  | Removal, check and installation of the receiver-dryer | | The power supply system, motor control / emission control and exhaust | | Systems of an electric motor | | A five-speed manual gearbox gear | | Automatic Transmission | | Transmission Line | | Brakes | | Suspension and steering | | Body | | Onboard electric | | The control body dimensions | |  | Wiring | | | |
|
|
|
 printable version
Removal, check and installation of the condenser K / V
Withdrawal | - The condenser is placed directly in front of the radiator.
- Support the wheel chock.
- Disconnect the negative wire from the battery.
- Forces trained professionals make detente a refrigerator path system K / V.
- Disconnect from the condenser refrigeration line - immediately plug the open ends of the choke connectors to prevent internal contamination of the working path K / V.
- Remove the condenser fan (see. Section Removal, check and installation of the fan of the condenser K / V).
 | - Remove the four mounting screws, remove the base from the bonnet and carefully, trying not to damage the fins, put it on the bottom section of the casing.
|
 | - With a special emphasis lock the hood in the raised position, then remove the top panel front cover assembly with the standard focusing hood.
|
- Release wiring harness from intermediate clamps on the front panel of the casing.
 | - Pulling up, release the wiring from the left and right sections of the front casing.
|
- Route between the radiator and the condenser sheet of cardboard.
 | - Release fixing nuts and fed up, remove the condenser - the heat sink is necessary to remove the reference pins and capacitor pull slightly forward.
|
|
|
Check | - Examine the condenser for any signs of leakage, deformation of plates and other mechanical damage to the heat exchanger, - if necessary, give an assembly for repair.
 | - Wear protective goggles and blow compressed air heat exchanger, manually remove the jammed foreign objects between the plates.
|
|
|
Setting | - Installation is the reverse order of disassembly of components - Ensure compliance with the Specifications of the Head of System of cooling, heating, ventilation and air conditioning systems to the efforts of a tightening of threaded fasteners.
- In conclusion, by trained specialist evacuated, vacuum check and charging of a refrigerator path system K / V, then start the engine, activate the K / V connectors and inspect the choke refrigerator path for signs of leaks. If necessary, make appropriate corrections.
|
|
|
|
