REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Sportage (1999 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Sportage
		Introduction
		Controls and operation receptions
		Current care and maintenance
		Engine
			Check compression pressure assessment cylinders
			Checking the engine by means of the vacuum gauge
			Accessory drive belt
			Petrol models
			Diesel models
				Lubrication System - general information
				Removing and installing engine
				Removal and installation of components of timing
				Check and adjust valve clearances
				Removing and installing intake manifold and exhaust manifold
				Service components of the cylinder head and camshaft
				Disassembly and assembly of the cylinder components of the service
				Removing and installing sump
				Removal, installation and maintenance of the oil pump
				Removal and installation of the oil cooler
				Removal and installation of a flywheel
				Removal and installation of lubricators
				Replacement seals crankshaft
		System of cooling, heating, ventilation and air conditioning
		The power supply system, motor control / emission control and exhaust
		Systems of an electric motor
		A five-speed manual gearbox gear
		Automatic Transmission
		Transmission Line
		Brakes
		Suspension and steering
		Body
		Onboard electric
		The control body dimensions
		Wiring

Removal and installation of the oil cooler

Details of installation of the oil cooler


1 - Hoses cooling path 2 - Socket cooler	3 - Oil line of the vacuum pump 4 - bolts and nuts assembling the oil cooler to the oil filter 5 - Building the oil cooler to the oil filter

The design of the oil cooler


1 - Oil Filter 2 - Heat Exchanger	3 - Cap 4 - Pressure Reducing Valve 5 - O-Rings

PERFORMANCE ORDER

Disconnect the negative wire from the battery.
Drain the cooling system (see chap. Current care and maintenance).
Disassembling components in numerical order, disassemble the oil cooler.
Installation is in the reverse order. Do not forget to replace the O-rings, track correctness of combination holes of the heat exchanger with the tabs on the filter housing. Remember to follow the requirements of Specifications of the Head engine to the efforts of a tightening of threaded fasteners.

Track hit the projection (1) on the oil filter housing in the opening (2) in the heat exchanger cooler.