add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz C-Class (from 1993 to 2000, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Mercedes-Benz C-class
Home
 
Mercedes-Benz
C-class
Introduction
Maintenance
Engines
The petrol engine (DB)
Introduction
An identification number
Engine
Cars with air conditioning
The bottom cover of the engine compartment
Covers cast holes
Chain tensioner
Cylinder head cover
Cylinder Head
Camshafts
Hydraulic bucket tappets
Valve stem seals
Valves
Valve guide
Valve seats in the cylinder head
Compression
V-belt
Fault Diagnosis (OBD)
General remarks
Repair work without dismantle of the engine
Engine Overhaul
Diesel engine (DD)
Lubrication system
Cooling
Heating and ventilation
Ignition system
Fuel system
Chassis
Steering
Brakes
Body
Electrical
 


Hit Counter by Digits


print page printable version

Cars with air conditioning




A warning

Do not open the coolant circuit unit. Coolant contains a substance which, in contact with the skin causing frostbite. The engine can also be removed without opening the coolant circuit.



PERFORMANCE ORDER
1. Remove the V-ribbed belt.
2. Remove the compressor cooling (arrows) and hook to the side of the wiring wire.
3. Disassemble the exhaust system.
4. Drain the coolant from the engine block.
5. Remove the propeller shaft from the gearbox and press. Loosen the bolts propeller shaft / intermediate pads, loosen the clamping nut and move back propeller shaft as far as possible.
6. Move repair jack with a wooden shim under the intermediate gearbox. Slightly lift the gearbox.
7. The rear bracket (12) with the bearing (18) to remove it. For this unscrew bolts (14 and 15) and nut (16) (see.
A warning
Disconnect "weight" (11) between the gearbox and the body. *

8. If you separate the engine from the transmission, remove the starter.
9. Disconnect the shift lever on the transmission. To do this, remove the retaining spring clips (arrows).
10. Automatic transmission: remove the plug and start switch lock reversing light, this white plastic stopper, turn on the switch for about 45 ?�, electrically disconnect the magnetic valve Kickdown. *
11. If separate the engine from the gearbox, unscrew the bolts connecting the lower engine / gearbox.
12. Pick up the motor cable. To do this in Thread the eye (arrow) suitable cable or chain. With the repair of the jack slightly raise engine.
13. Remove the screws with hexagon (arrow) of the front engine mounts from the bottom of the cross-member of the vehicle. The picture shows a bolt of the right support.
14. Remove the upper bolts connecting the engine to the transmission.
15. Press the engine pry bar from the gearbox and prepodnimite.
16. The engine and gearbox, turn sideways and lift. Stick to the position of the engine at an angle to the checkpoint in the process of lifting the maximum angle of inclination of 45 ?�.

A warning

Lift the system very carefully, so as not to damage the car body. This special watch rear lugs of the engine and engine oil filter. Also, check the disconnection of all connections.


17. If the engine / gearbox dismantled together, separate gearbox.




« previos page
Functioning
next page »
The bottom cover of the engine compartment

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.