printable version
Lifting sunroof mobile panel
| And the situation - closing;
The position - opening;
the C - open the hatch to the position of maximum comfort;
position D- rise | The panel is opened and closed with the ignition switch by turning and pressing or pulling the switch panel is raised or lowered.
On vehicles with central locking panel can be opened or closed for 10 minutes after the ignition is turned off, until one of the front doors have not yet opened. Closing - position A
To close, turn the switch to A.
The mechanism of the closing panel is equipped with overload protection. If the motion is complicated or the panel that either prevents the panel immediately reopened.
You can close the bar, if you hold down the switch to the front or back up until the panel is completely closed. Now the panel is closed without overload protection.
After disconnecting and then joining the vehicle's battery may happen that the panel is completely closed. In this case, you should keep the switch is pressed from front or from behind for 10 seconds. Opening - The position
Turn the dial clockwise until the panel the desired position. In the C hatch opens to the position of maximum comfort.
If you want to move the bar completely, turn the switch on to position B. In this position, however, you may annoy aerodynamic noise.
For vehicles with a glass roof panel is slid in the panel at the same time automatically opens the sliding screen to protect against strong sunlight. In the closed roof panel as desired it can be shifted back by hand. Lifting - position D
Depending on the angle of rotation of the panel rises to a certain height. In position D panel is fully raised. Automatic closing panel
On vehicles with central locking sliding panel can be closed from the outside when locked one of the front doors of the car. Hold key in locking position as long as the panel is closed. Procedure for electric faults | At malfunction of the electric roof can be closed manually.
|
PERFORMANCE ORDER | 1. Remove the plastic cover on the back side with a screwdriver. | 2. Remove the crank knob from the holder cover, insert it in the hole (breaking the resistance of the spring), and close the sliding panel. | 3. Insert the knob into the holder and replace the cover. |
|
|