 printable version
Control manual gearbox
| Fig. 1.181. The switching circuit of a mechanical transmission
|
Driving the shift is shown on the gear lever knob. All transfers to move forward are synchronizers and therefore easy to be included. To enable reverse gear, move the gearshift lever into position ?�R?�, pre-pulling foot against the erroneous inclusion of transfer.
NOTE When reverse gear is engaged when the vehicle is stationary, hold the gear lever at least 3 in a neutral position. After that, move the lever to reverse gear. In cold weather could freeze the grease in the gearbox and, until it warms up, gear changes can be difficult. This - is normal and does not damage the transmission. If the vehicle is completely stopped, and the 1st gear or reverse gear ?�R?� are included with difficulty, turn the lever to position ?�N?� (?�Neutral") and release the clutch pedal. Depress the clutch pedal again and move the lever to position 1 or ?�R?�. While driving a car, your hand is constantly on the gearshift lever operations, as This can lead to premature wear of the rocker fork transmission mechanism. |
ATTENTION By switching the lever from position 5th gear position 4th gear, be careful not to include the second gear by mistake. Such an abrupt gear changes can cause an excessive increase in engine speed (tachometer needle in the red zone). The maximum permissible engine speed can damage the engine., |
Using the clutch Before turning the gear fully depress the clutch pedal and then slowly let her go. Pressing the clutch pedal must be carried out only after full reset. Do not keep your foot on the clutch pedal while driving. This can lead to clutch wear. Do not use the clutch to hold the car on an incline. To do this, you must use the parking brake. Avoid sudden and repetitive releasing the clutch pedal. For economical driving is recommended to change gears at speeds specified in the table.
Receptions correct driving Do not roll downhill in neutral gear. It is very dangerous. Always keep the transfer included. Do not have a habit of driving in which the accounts brake abruptly. This leads to overheating and loss of braking effectiveness. On the downhill to prevent overheating of the brakes should be applied engine braking (including downshifts). When the downshift slightly slow down the car. This helps to prevent an excessive increase in engine speed, which can lead to engine damage. If a strong crosswind reduce speed of the vehicle. This will improve its handling. Before switching on the reverse gear, make sure the vehicle is completely stopped. Otherwise, you may damage the transmission. to put the lever into reverse, first depress the clutch pedal, move the lever to neutral, wait 3 seconds, and then move the lever to reverse position. Be especially careful when driving on slippery roads. Be especially careful when braking, acceleration and gear changes. On a slippery road abrupt change in vehicle speed can cause you to lose traction with the road, and loss of vehicle control.
|
