add to favorites

REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Rio (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Kia Rio

Home

Kia
	Rio
		Instructions
		Engines A3E, A5D
		Greasing system
		Cooling
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Wheels and tires
		Steering
		Brakes
			Technical data
			Check the brake servo using devices
			One-way vacuum valve
			Vacuum brake booster
			Bleeding the hydraulic system of a drive of brakes
			Check of brake tubes
			Check and replacement of brake hoses
			Brake pedal
				Installation height of the brake pedal
				Free running of the brake pedal
				The distance from the floor of the brake pedal
			Replacing the front brake pads
			Replacing brake pads on the rear drum brakes
			Repair the brake caliper
			Repair of the working brake cylinder
			The main brake cylinder
			The pressure
			Parking brake
			ABS control unit
			Hydraulic control unit (HCU)
			The front wheel speed sensor
			Rear wheel speed sensor
			A gear rotor of the wheel speed sensor
			Main inspection
			Checking functionality
		Body
		The air conditioning system
		Electrical equipment

Hit Counter by Digits

printable version

Brake pedal

Brake pedal

1 - lock washer;
2 - a nut;
3 - a bolt;
4 - the plug;
5 - spacer;

6 - pin head and the cotter pin hole;
7 - a returnable spring;
8 - pin;
9 - rubber stop;
10 - brake pedal.

Withdrawal

PERFORMANCE ORDER

1. Disconnect the negative battery terminal.

2. In the passenger compartment, remove the cotter pin that secures the pin with a head and an aperture under the pin and remove the pin.

3. Unscrew the nut and remove the retainer.

4. Remove the spacer from the hinge pin.

5. Move the pin to the right and remove it.

6. Remove the brake pedal return spring and the spacers.

7. If necessary, remove the cover plate of the brake pedal and the rubber stop.

Setting

PERFORMANCE ORDER

1. If necessary, install a rubber emphasis of the brake pedal, the brake pedal and the brake pedal bushing.

2. Install the spacer and the brake pedal pivot bolt.

3. Install the brake pedal return spring.

4. Install the clutch pedal.

5. Install the spacer clutch pedal.

6. Install the pivot bolt, washer and screw the nut.

7. Set the pin with a head and an aperture under the pin and new cotter pin.

8. Attach the wire to the negative terminal of the battery.

9. After installation, check and adjust the height of installation of a pedal and brake pedal free wheeling.

« previos page
Check and replacement of brake hoses

next page »
Installation height of the brake pedal

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.