add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Rio (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks
Kia Rio
Home
 
Kia
Rio
Instructions
Engines A3E, A5D
Greasing system
Cooling
Fuel system
Ignition system
Coupling
Transmission
Axes and power shafts
Suspension
Wheels and tires
Steering
Brakes
Technical data
Check the brake servo using devices
One-way vacuum valve
Vacuum brake booster
Bleeding the hydraulic system of a drive of brakes
Check of brake tubes
Check and replacement of brake hoses
Brake pedal
Replacing the front brake pads
Replacing brake pads on the rear drum brakes
Repair the brake caliper
Repair of the working brake cylinder
The main brake cylinder
The pressure
Parking brake
ABS control unit
Hydraulic control unit (HCU)
The front wheel speed sensor
Rear wheel speed sensor
A gear rotor of the wheel speed sensor
Main inspection
Checking functionality
Body
The air conditioning system
Electrical equipment
 


Hit Counter by Digits


print page printable version

Vacuum brake booster



Vacuum brake booster

1 - the brake pipe;
2 - a nut;
3 - an electric socket;
4 - the master cylinder;
5 - a lining;
6 - a vacuum hose;
7 - pin;
8 - pin head and the cotter pin hole;
9 - a nut;
10 - the brake servo.

Withdrawal

PERFORMANCE ORDER
1. Disconnect the electrical connector from popolnitelnogo the brake fluid reservoir.
2. Disconnect the brake pipes.
3. Remove the brake master cylinder.
4. Remove the vacuum hose from the vacuum brake booster.
5. In the passenger compartment, remove the cotter pin that secures the pin head and the cotter pin hole.
6. Remove the pin with a head and a hole for the pin.
7. The assistant should support the brake servo in the engine compartment.
8. Remove the four screws fixing the brake servo to the bulkhead.
9. Remove the vacuum brake booster.
10. Remove the pad holder of the vacuum brake booster.

Setting


A warning

Lubricate the pin head and the cotter pin hole with lithium grease.


PERFORMANCE ORDER
1. Install in the reverse order of removal.

The inhaling moment: 18,6-25,5 N ??? m

2. Fill the tank popolnitelny brake system with brake fluid up to the MAX mark.
3. Remove air from the hydraulic circuit brake system.
4. Check for leaks of brake fluid.
5. Check and, if necessary, adjust the height of installation of a pedal and brake pedal free wheeling.




« previos page
One-way vacuum valve
next page »
Bleeding the hydraulic system of a drive of brakes

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.