printable version
Cabin lighting - lamp replacement, check of serviceability of functioning
The main cabin lighting (all models) Design salon lamp Replacing the lamp | | - Accurately having hooked using a flathead screwdriver, remove the ceiling fixture salon.
|
- Remove the 2-lamp plinth of spring-loaded contacts, and install in its place a replacement.
|
|
Checks The three-position switch salon lamp | - Remove the bowl and remove the bulb.
| - Remove the three mounting screws, remove the lamp and disunite its wiring connector.
|
- Check the distribution of conductivity between terminals pin lamp in each of the provisions of the three-position switch (see. Table).
Check of serviceability of functioning of the three-position switch salon lamp - If necessary, replace.
- Installation is the reverse order of dismantle of components.
|
|
Door sensors, switches | | - Bend the boot and remove the screw fastening of the switch.
|
| - Using an ohmmeter / lamp probe Check the operation of the switch - in the released position conductivity should take place down - no.
|
|
|
Lantern lighting luggage (only 5-door models) | - Open the tailgate.
| - Accurately having hooked using a flathead screwdriver, remove the lens of the luminaire.
|
- Depressing the spring clamp, carefully remove the lamp, - try not to drop it into the cavity under the finish panel, - and install in its place a replacement.
- Put in place the lens flashlight, - track reliability snaps into the locking tabs.
|
|
|