printable version
Removal, installation and adjustment of the headlight units
general information Block lights mounted on the support brackets located between the grille and the front direction indicators assemblies. Fixing the lens unit is performed by means of two screws and a single torsion spring, two screws are used to adjust the direction of the optical axis of the headlights. Having an aerodynamic shape headlamp lens is attached to the plastic reflector, inside of which is fixed pin equipped with a built-in halogen lamp - the lamp is inserted into the rear of the building and mounted spring clamp, mounted outside the protective rubber boot. Visually assess the condition of lenses, lamps and electrical connector block lights, check the yellow 20-amp fuse in the mounting block. Refitting Adjustment | | - Adjusting the direction of the optical axis of the headlight is performed in the horizontal and vertical planes by means of two screws located at the upper side of the assembly.
|
|
|
|