REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Sportage (1999 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Sportage
		Introduction
		Controls and operation receptions
		Current care and maintenance
		Engine
		System of cooling, heating, ventilation and air conditioning
		The power supply system, motor control / emission control and exhaust
		Systems of an electric motor
		A five-speed manual gearbox gear
		Automatic Transmission
		Transmission Line
		Brakes
			General information and safety measures
			Checking and adjusting the brake pedal
			Check the parking brake lever
			Check of serviceability of functioning of the vacuum brake booster
			Check the bypass valve differential pressure control (models without ABS and EBD)
			Removing and installing brake pedal
			Removal, service and installation of the main brake cylinder
			Removal and installation of assemblage of the vacuum amplifier of brakes
			Assessment of the degree of wear, replace disc brake pads front wheels
			Dismantling the front wheel brake mechanism, assessment of the disk
			Removal and installation of flexible brake hoses hydraulic path of brake mechanisms of forward wheels
			Service drum rear brakes
			Removing and installing handbrake lever, adjustable drive cable
			Bleeding the brakes
			Read the faults ABS / EBD, clearing processor memory
			Removal and installation of hydraulic and electronic control unit ABS / EBD
			Removal, check installation of wheel gauges ABS
			Replacing the rotors front wheel ABS sensors
		Suspension and steering
		Body
		Onboard electric
		The control body dimensions
		Wiring

Removal and installation of assemblage of the vacuum amplifier of brakes

When removing proceed in numerical order components.

Dismounting assembly brake servo


1 - Connectors wiring gauge-switch of the brake fluid level and differential gauge-switch 2 - Vacuum hose 3 - Brake line 4 - Bolt 5 - control valve 6, 9 - Nuts	7 - Support bracket control valve 8 - GTZ 10 - Lock 11 - Finger 12 - servo 13 - Gasket

PERFORMANCE ORDER

Remove the GTZ (see. Section Removal, service and installation of the main brake cylinder).
Disconnect from the assembly of the brake booster vacuum hose.

In the car, remove the clamp and remove the finger attachment push rod to the brake pedal.

At the rear of the engine compartment bulkhead release the four mounting screws and remove assemblage of the vacuum amplifier with a follower of GTZ.

Installation is in the reverse order - Ensure compliance with the Specifications Chapter brake system to the efforts of a tightening of threaded fasteners. Do not forget to adjust the length of the push rod (see. Section Removal, service and installation of the main brake cylinder) and the pump hydraulic path (see. Section pumping the brakes)