|
|
 printable version
Removal, check of a condition and installation of the release bearing and release lever
 | Remember that generated in the process of wear of the friction linings slave drive clutch dust can contain unhealthy asbestos. Do not blow off the dust with compressed air and avoid inhaling it. Do not wipe the clutch components petroleum solvents, - use only the special brake cleaners or pure methanol. Before disposing of used rags piled in sealed containers. |
REMOVAL | 1. Disconnect the negative wire from the battery. | If installed on the car stereo is equipped with a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action! |
2. Remove the gearbox (see. Removal and installation Manual transmission).  | 3. Remove the lever of the clutch with the ball stud and then remove from the lever release bearing. |
|
|
CHECK |  | Hold the outer ring of the bearing, press two fingers inside and rotate it. The bearing should rotate freely and quietly, otherwise it must be replaced. Wipe with a clean cloth bearing and check for signs of wear, cracks and other mechanical damages. Normally, release bearing replacement is performed every time the service components of the clutch. In no case do not wash the bearing in solvent in order to avoid infringement of tightness of its assembly. Check the release lever for cracks and signs of strain. |
|
|
INSTALLATION |  | 1. refractory greasing grease the bearing surface of the Phewa. |
 | 2. The same greasing grease a nest under landing of the ball stud on the reverse side of the lever assembly off and landing slot under the slave cylinder pushrod. |
3. Put the assembly clutch lever retaining spring bearings and spherical thrust bearing. 4. Put the thrust bearing in the front bearing holder of the primary shaft of the gearbox, while passing off the end of the arm through the hole in the clutch housing. Densely plant to plug off the finger of a spherical ball bearings.
5. Lightly grease the refractory in contact with the surface of the petals of the diaphragm spring release bearing.
6. The further installation is made in the reverse order of dismantle of components. |
|
|
|
