REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Maxima QX (1993 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Nissan
	Maxima QX
		Introduction
		Operating Instructions
		Adjustment and routine maintenance
		Engine
		System of cooling, heating
		The power supply system and release
		Electric motor
			General information and precautions
			Starting the engine from the auxiliary power supply
			Check and replace batteries
			Check and replacement of wires of the battery
			Ignition System - general information and precautions
			Check the functioning of the ignition system
			Check and replace the ignition coils
			Check and replacement of the power transistor (models 1993 and 1994 issue.)
			Check, adjustment, removal and installation of the distributor of ignition (models 1993 and 1994 issue.)
			Check and adjust the ignition timing settings
			Charge system - the general information and precautions
			Checking the status of the charge
			Removing and installing the generator
			Start system - the general information and precautions
			Check of serviceability of functioning of a starter and start chain
			Removing and installing starter
			Replacement of the traction relay
		Engine Control Systems
		Transmission
		Coupling and power shafts
		Brakes
		Suspension and steering
		Body
		Onboard electric

printable version

Removing and installing starter

Construction starter S114-461 (models 1993 and 1994 issue.)


1 - Holder 2 - Coupling 3 - Bolt (6.4 ÷ 7.8 Nm) 4 - Housing 5 - Spring 6 - Shim 7 - The nut (7.4 ÷ 9.8 Nm) 8 - Cover 9 - Return spring 10 - Retaining Ring 11 - Lever 12 - Bellow	13 - The traction relay 14 - Anchor 15 - The field winding 16 - Housing 17 - Brush (-) 18 - Spring brush 19 - Back cover 21 - Bolt (4.9 ÷ 6.4 Nm) 22 - Brush () 23 - Val

Construction S114-801A starter (models from 1995 MY.)


1 - Housing gears 2 - Adjustment lever 3 - Bellow 4 - The traction relay 5 - Disc 6 - The nut (7.4 ÷ 9.8 Nm) 7 - Cover 8 - internal gears 9 - Bolts (4.9 ÷ 6.4 Nm) 10 - bolts (6.4 ÷ 7.8 Nm) 11 - Emphasis gear 12 - Gear 13 - Retaining Ring	14 - Central suspension (P) 15 - the gear shaft 16 - Planetary gear 17 - Central suspension (A) 18 - Housing 19 - Anchor 20 - Brush () 21 - Brush (-) 22 - Spring brush 23 - Thrust Washer 24 - Back cover 25 - Brush holders

PERFORMANCE ORDER

1. The design of the starter is shown in the illustrations.
2. Disconnect the negative wire from the battery.
If installed on the car stereo is equipped with a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action!

3. Remove the air cleaner assembly with an inlet duct (see chap. The power supply system and release).
4. Disconnect the wiring from the starter assembly with the traction relay.

5. Give fixing bolts and separate the assembly from the starter motor.

« previos page
Check of serviceability of functioning of a starter and start chain

next page »
Replacement of the traction relay