| 1. Lift the front of the car and establish on supports. |
| 2. Remove the front wheels. |
| 3. Pull the caliper, the piston entered the cylinder, making sure the liquid level in the tank. |
 | 4. If necessary, press the piston by means of a clamp. |
 | 5. Remove the caliper fingers (Stelka). |
 | 6. Remove the caliper from the disc. |
| 7. Keep in mind that the outer strip can remain on the bracket. |
| 8. After removal of the caliper on the brake pedal is not pressed. |
 | 9. Fix the caliper so that it does not hang on the hose. |
 | 10. Remove shims. |
 | 11. Remove the pads. |
 | 12. Remove the pad retainers. |
| 13. Check the thickness of the friction linings. |
| 14. If the thickness is at least one less than normal lining or pads are very dirty, replace all the pads in the kit on the same axle. |
| 15. Find and eliminate the cause of contamination. |
| 16. Do not rearrange the blocks to compensate for wear. |
| 17. If the condition is satisfactory pad, then clean them by removing grime and large particles. |
| 18. Clean the contact surface and pads in the caliper bracket. |
| 19. Before assembly, check the freedom of movement of fingers in the bracket and caliper as well as the integrity of the rubber covers. |
| 20. Check the seals of the piston, the piston corrosion and traces of leakage. |
| 21. If the pads will vary, it should displace the piston to provide a place for shoes. |
| 22. By moving the piston watch liquid level, excess fluid should be removed, or a rubber bulb syringe. |
| 23. Lightly grease the plate pads, gaskets and spring clips antinoise special grease. |
| 24. Install the brackets, pads and pads in the caliper bracket. The outer strip is installed in the bracket and the inside - in the caliper. |
| 25. Make sure that the latch inner pads came into engagement with the piston. |
| 26. Establish a support, lubricate your fingers slide fixing structure and tighten. |
| 27. Tighten your fingers with the set moment. |
| 28. Check the freedom of movement of the caliper on the fingers. |
| 29. Repeat these steps for the other wheel brake. |
| 30. Tap a few times on the brake pedal. |
| 31. Establish wheels, lower the car. |
| 32. Check the fluid level. |
| 33. Before leaving, check the brakes. |
Pads are changed only in the package on the same axle. When cleaning pad to remove dust and dirt by wiping with a cloth soaked in alcohol, purging is prohibited. 
