printable version
Rear axle - Removal and installation
Attention! This description refers only to the removable gearboxes, which are mounted in the axle beam. On the part of the car set molded rear axle repair is performed only in the service station. |
1. Raise the rear of the vehicle. 2. Drain the oil from the gearbox. 3. Remove the rear part of the propeller shaft from the gearbox. 4. Bring the two semi-axis of the differential gear (half-line, you can not get). 5. Evenly and gradually in diagonal sequence, remove the screws and remove the gear case gearbox (photo). 6. To repair the gear needed special equipment and tools. Repair of this unit in the home beyond the present description. Therefore, if an abnormal work gear, it must be replaced, which is a more appropriate cost. 7. Remove any old gasket and install new gasket. 8. Install in the reverse order of removal. Tighten bolts with the set moment. 9. Fill the gearbox oil (Chapter 1).
|