printable version
The clutch pedal - removal, installation and adjustment
Withdrawal 1. Disconnect the master cylinder pushrod from the pedal. 2. Remove the bracket from the stop pedal or the clutch sensor. 3. Unscrew the nut and remove the pedal shaft (photo). 4. The spring return 5. Sensor clutch 6. Switch ASCD (cruise control) 7. Servopruzhina 8. Pedal 4. Remove the pedal and spring: 5. Rinse the parts in a solvent and replace those that are worn out or damaged. The sleeve is pressed into the pedal, so in the event the wear sleeve is changing the whole foot. Setting 6. Installation is performed in reverse order.
| 2.6 When installing the pedal lubricate these places 1. Grease |
| 3.3 The master cylinder is attached to the bulkhead |
Attention! Grease the pedal shaft, thrust pad and servopruzhinu pin pusher of the main cylinder (photo) |
Adjustment 7. After installation, check the height and free travel. If necessary, adjust by following the operation described in Chapter 1.
|