REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Golf IV (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Golf 4
		Instructions
		Engine
		Cooling system
		Fuel System
		Exhaust system
		Ventilation and heating system
		Coupling
		Transmission
		Suspension brackets and power shafts
		Steering
		Wheels and tires
		Brakes
			Technical specifications
			ABS / EBV / EDS / ASR / MSR
			Replacing the front brake pads on support FS-III
			Replacing brake pads on a support FN-3
			Replacing the rear brake pads on disc brakes
			Brake disk
			Adjusting handbrake
			Replacing the rear brake pads Drum brakes
			Removing and installing rear working brake cylinder
			Bleeding the hydraulic brake system
				Bleeding - the basic method (two persons)
				Bleeding - using set with the unidirectional valve
				Bleeding - using a set of squeezing
				All methods
			Brake pipelines and hoses
			Check the brake servo
			Removal, installation and adjustment of brake light switch
			Removal and installation of cables of a manual brake
			Key brake failure
		Body
		Electrical equipment and wiring

printable version

Bleeding - using a set of squeezing

When pumping this method requires a large amount of hydraulic fluid to prevent air from entering the master cylinder during bleeding that often occurs if you do not maintain the level of liquid in a tank.

Pumping pressure is particularly effective when the system is difficult to pump or when undergoing a complete pumping system during normal brake fluid change.

PERFORMANCE ORDER

1. Using a set of pumping pressure required to feed him the compressed air, which can be used to inflate the tire of a spare wheel. Reduce tire pressure to the value specified in the instruction manual kit.

A warning

Volkswagen recommends the use of compressed air is supplied at a pressure of 2 bar.

2. Connect filled with brake fluid container to popolnitelnomu master cylinder reservoir.

3. pumping process begins after unscrewing the bleeder on the half turn.

4. After the leak will stop when the brake fluid with air bubbles and will follow only clean brake fluid, tighten the bleeder valve until it stops.

« previos page
Bleeding - using set with the unidirectional valve

next page »
All methods