printable version
Positions selector
| Located on the instrument panel display, which shows in what position is the selector. |
A warning Never during movement does not move the lever to position "R" or "P". Transmission can fail - there is a risk of an accident!
P - Parking lock
The drive wheels are mechanically locked.
The selector must not be moved to this position only when the vehicle is completely stopped. Before turning on and off position "P" must be pressed the lock button on the handle of the selector. Before turning off this position when the ignition should be further depress the brake pedal. R - Reverse
Position backing should be included only when completely stopped the car and at engine idle. Before changing the position of the "R" position from "P" or "N" to press the brake pedal and push the lock button in the handle of the selector.
In the position "R" when the ignition burn reversing lights. N - neutral position (idle position)
In the derivation of the selector from position "N" at a speed of 5 km / h, and when the vehicle is stationary and the ignition switched on, press the brake pedal and push the lock button on the handle of the selector. D - long advance
Four transfer switch from low to higher and vice versa automatically, depending on the engine load and the speed.
Under certain driving conditions it is advisable to temporarily use one of the following positions. 3 - position for the "rolling" road sections
Such a position of the selector is recommended when a certain driving conditions at the position of the selector in the position "D" occurs frequently switched from the 3rd to the 4th gear and reverse.
To translate the selector in this position you must press the lock button in the handle of the selector. Automatically switched up and down the first, second or third transmission depending on engine load and speed, 4th transfer locked. Through this also increases the braking effect of the engine fuel cut.
2 - position of the mountain road sections
This position is recommended for prolonged ascents and descents.
Automatically switch up and down 1st and 2nd gear depending on engine load and speed, third and fourth transmission remain blocked to avoid unnecessary upshift. It also increases the efficiency of engine braking. 1 - position for the mountain road sections with steep slopes
The choice of this position is recommended when driving on steep inclines.
When this position you must press the lock button on the handle of the selector. The car moves only in first gear, second, third and fourth transfer blocked to avoid unnecessary upshift. This achieves the greatest possible effect of engine braking.
Cruise control in position "1" of the selector can not be used. A warning With manual switching DESC can go to the position "W", "2" and "1", but switching to a lower gear is automatically only when, after switching is not exceeded the maximum permissible engine speed.
|