REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Jeep Grand Cherokee (from 1993 to 1999, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Jeep
	Grand Cherokee
		Introduction
		Adjustment and routine maintenance
		The straight six-cylinder engine
		The V8 engine
		Procedure of the general and engine major repairs
		Systems of cooling, heating and air conditioning
		The power supply system and exhaust
		The system of electric motor
		Systems of decrease in toxicity of the fulfilled gases and engine management
		Manual box of a gear change
		Automatic Transmission
		Transfer Case
		Clutch and transmission line
			general information
			Clutch - a general description and check of serviceability of functioning
			Removal and installation of components of the hydraulic clutch system
			Removal, check of a condition and installation of components of the clutch
			Removal, check of a condition and installation of the clutch release bearing
			Check and replacement of the directing bearing
			Cardan shafts, differentials and bridges - general information
			Checking the status of the transmission line
			Removing and installing drive shafts
			Replacing the universal joints
			Replacing the oil seal differential pinion shaft
			Removal, service and installation of the hub and bearings (front wheel)
			Removal, major repairs and installation of the front drive shaft
			Removal and installation of the front axle assembly
			Removing and installing the rear axis and bearing assembly
			Removing and installing rear axle assembly
		Brakes
		Suspension and steering
		Body
		The system of on-board electrical equipment
		Controls and operation receptions

Clutch and transmission line

Specifications

Type of fluid

Efforts of a tightening of carving connections, N ??? m

Clutch

Clutch master cylinder / reservoir
Nuts of fastening of the main cylinder	22.6 - 33.9
Tighten the screws on the tank	3.4 - 5.7
Nuts of fastening of the clutch slave cylinder	22.6 - 33.9
Bolts flywheel clutch
1993 and 1994,
Bolts 5/16 inch (8 mm)	23
Bolts 3/8 inch (9.5 mm)	41
1995	52

Transmission line

The propeller shaft
Front propeller shaft
All drive shafts (except the third type, installed on the model 1995 issue.)
The clamp screws of the cross	19
Bolts to the holder of the universal joint cross transfer case	27
The propeller shaft third type (some of the models 1995 issue.)
Bolts constant velocity joint (CV-joint) to the flange of the pinion	41
Bolts to the holder of the universal joint cross transfer case	27
Lock-nut	115
Rear propeller shaft
Tighten the screws on the universal joint yoke to the rear axle of the cross	19
Nut pinion shaft of the differential	217 - 353
Nut Kit front drive shaft	237
Bolts front hub assembly to the steering knuckle	102