add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 323 (1985 release)

general info. full specifications. diagnostics. hints. tips. tricks
Mazda 323
Home
 
Mazda
323
Introduction
Gasoline engines
Engine oil
Engine cooling system
Ignition system
The power supply system, the carburettor, fuel injection system
Diesel engine
Exhaust
Coupling
Manual gearbox
Automatic Transmission
Suspension and steering system
Brakes
Wheels and tires, a body, car coloring, care of the car
Electrical system
Troubleshooting the electrical system
Check the switch on the power transmission
Relay test
Check the wiper motor
Checking the direction indicators
Check stoplights
Check the rear window defogger
Disconnecting and connecting the connectors
Fuse
Replacing fuses
Removing and installing battery
Battery check
The battery discharges itself
Charging the battery
Storage Battery
Generator
Security measures for the alternator
Check the generator voltage
Removing and installing the generator
The components of the generator
Dismantling generator / replacing the carbon brushes
Removing and installing starter
Check / replacement of the traction relay of a starter
Heater, illumination system, devices
Controls and operation receptions
Electrical diagrams
 


Hit Counter by Digits


print page printable version

Check the generator voltage



PERFORMANCE ORDER

  1. Connect a voltmeter between the positive and negative terminal of the battery.
  2. Start the engine. When starting voltage must not fall below 8 (at an ambient temperature of + 20 ?� C).
  3. Increase the number of turns to 2000 rev / min. The voltage should be 14.1 - 14.7 V. This indicates that the alternator and the regulator work. The generator voltage must be higher than the battery voltage to the battery is recharged while driving.
  4. Check the stability of adjustment. To do this, turn on the high beam and repeat the measurement at 2000 rev / min. The measured voltage is not more than 0.4 V above the previously measured value.
  5. If the measured values lie outside the acceptable limits, check the generator in the workshop.




« previos page
Security measures for the alternator
next page »
Removing and installing the generator

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.