|
|
 printable version
Refitting the wheel brake cylinder
Withdrawal | - Remove the brake pads.
- Loosen the union nut of the brake pipe on the wheel cylinder from the back side.
 | This will drain the brake fluid substitute specially designed vessel. Observe the rules for handling brake fluid. See section Bleeding the braking system. |
 | - Remove the 2 bolts -1- wheel cylinder on the back of the brake shield.
|
- Remove the wheel brake cylinder.
- Close brake hose suitable stopper to avoid greater loss of liquid and the penetration of dirt.
|
|
Setting | - Install the wheel cylinder to the brake shield and tighten the 2 bolts to 10 Nm.
- Pull the plug and tighten the cap nut brake pipe with a force of 20 Nm.
- Install the brake pads.
- Bleed brake system. Thus, usually only enough to pump the cylinder, wherein the conduit tampered. If the brake pressure after pumping floats should bleed the entire system.
- Some times strongly press the brake pedal. This regulated rear brakes.
|
|
|
|
