printable version
Adjusting sunroof
Electric sunroof
| Adjusting the trailing edge of the hatch with the electric drive |
| - Remove the trim from the sunroof by loosening the bolts of sliding brackets and slide brackets pressing inward while holding the hatch in a central position in the opening. Tighten the screws.
- To adjust the height of the leading edge of the hatch, loosen the screws that secure the rails and turn the adjusting screws with slot so that the front edge of the hatch closed flush with the roof surface or slightly down (within 1.0 mm). Tighten the screws that secure the rails.
- To adjust the height of the trailing edge of the roof hatch Close the hatch, loosen the nut and turn the adjusting plate with a screwdriver so that the trailing edge of the hatch flush with the roof surface or slightly raised (within 1.0 mm).
- Replace trim hatch.
|
|
Sunroof with a mechanical drive
| - Remove the trim from the sunroof, loosen the bolts sliding brackets and slide brackets pressing inward while holding the hatch in a central position in the opening. Tighten the screws.
- To adjust, loosen the locking rod nut and adjust the position of the sunroof so that it fits close to the front gasket, and then tighten the nuts. Crack open the hatch, loosen the lock nut and adjust their rods so that the handle could put the hatch in any position.
- To adjust the position of the front edge of the hatch height loosen the screws that secure the rails and turn the adjusting screws with slot so that the front edge of the hatch closed flush with the roof surface or slightly lower (within 1.0 mm). Tighten the screws that secure the rails.
- To adjust the position of the trailing edge of the hatch, turn the adjustment screws on the rear bracket so that the trailing edge of the hatch flush with the roof surface or slightly raised (within 1.0 mm).
- Refit the back. If the handle of the hatch knocking while driving, place a strip of felt under it.
|
|
|