printable version
Removing and installing tailgate (station wagon models)
Withdrawal | - After opening the tailgate, turn the key off the lock and remove the door trim panel (six screws).
- Remove the screws lining the inside handle, remove liner, and then release the trim panel from the latch.
- Unscrew and remove the bottom cover.
- Remove the Phillips screws from the inside door handle.
- Unplug terminal block wiring from the right side of the lock, remove the lock from the pull off the left side of the castle.
- On models with central locking disconnect draft from the vacuum actuator.
- Remove the bolts from the lock and pressing the lock lever set it to the locked position. Remove the lock through the opening frame of the door.
|
|
Setting Install in reverse order, making the following adjustments. On models equipped with a central locking system, adjust the vacuum actuator so that after unlocking Rod had no backlash. The value of a free wheeling external handle should be equal to 1.0 mm; if necessary, move the safety stop, and then insert a screwdriver through the hole for the top bolt and adjust the position of the lock. Wrap and tighten the bolt.
|