- Remove the floor mats of the recesses front of the cabin, and then the lower dash panel.
- Remove the center console.
- Slide the front seats in the rearmost position.
- Drain the engine cooling system.
- Disconnect heater hoses in the engine compartment.
- Remove the glove box and unplug the wiring light switch glovebox.
- Unscrew and remove the air lines to the rear seats and air ducts installed in the tunnel transmission.
- Disconnect the heater air supply hose, remove the choke fresh air.
- Remove the mounting bracket to the transmission tunnel, remove the bolt from the dashboard.
- Unplug the wiring connector and all its connectors. Disconnect the cable drive and heater control.
- Remove the nuts upper and lower bolts.
- Close the damper of outer air, then downwards, output from the nozzle heater heating the glass and remove it along with the supply and discharge tubes of liquid.
- Installation is the reverse order of removal, moisten nozzle heated windscreen with soapy water. Bottom bracket to be installed in the position shown in the figure. Fill the cooling system.
|
|