printable version
Removing and installing windscreen and rear window
Windshield
| Set windscreen |
| - Remove the interior trim moldings, leaving the upper molding.
- The blunt screwdriver to release the internal rubber seal.
- With the help of an assistant gently squeeze inside the windshield to remove it from the vehicle.
- Remove the rubber seal and corner trim moldings, and then remove the seal from the glass.
- Clean the opening of the body, rubber seals and windshield.
- Put on the rubber seal on the glass, then dip moldings and corner covers in warm, soapy water and set them on the seal.
- Cut a piece of string length greater than the perimeter of the windshield, dip it into the soapy water and fill it into the groove of the seal.
- Apply a bead of sealant 8 mm vertical pillar body.
- Place the glass in the body opening so that the ends of the cord are in the middle of the lower edge of the glass, and then press down on the glass, while the assistant pulls the cord, so that the seal on the flange opening sat.
- Replace the internal moldings.
- Outside the perimeter of the glass press-fit hermetic seal between the glass and the body and remove excess sealant.
|
|
Rear window | - Disconnect the wiring of the heated glass, remove the upholstery rear pillars, and proceed with the windshield.
|
|
|