printable version
Removal and installation of doors
Withdrawal | - Open the door to failure and prop it from below a jack stand or by placing them under any soft material.
- Remove the stopper from the opening of the door pillar.
- If the car is equipped with power windows, disconnect the wiring.
- Lock the hinge plates on the frame doors, unscrew the screws and remove the hinge. Remove the door from the car.
|
|
Setting Installation is the reverse order of removal. If the loops are fixed in the same position, and a special adjustment is not required. If you want to raise or lower the door or make its position flush with the body, loosen the hinge bolts and slide the door in the desired direction. Clearance contour doors must be the same on both side edges and top.
Adjusting the striker plate Adjusting the striker plate at the front of the body affects the closing of the door and on the protrusion or ceasing edges of the door with respect to the panel or pillar. For adjusting the position of the retainer plate fixing screws of its weakened so that it is hardly shifted, after which the door closes. Thus, the position of the door. This is followed by gently open the door and tighten the screws to failure. If necessary, from the retainer plate are removed or added to the shims, which allows to obtain a good closing. Sometimes it is advisable to adjust the door so that it
performed at the trailing edge of 1.0 mm relative to the rear door or body panels and thereby reduces airflow noise.
|