 printable version
No-load speed and the maximum speed
Check / adjust the idle speed and the maximum speed
Since diesel engines have no ignition system requires a special tachometer, working on solar cells.
| PERFORMANCE ORDER | | 1. Warm up the engine to operating temperature. Coolant Temperature min. +80 ?� C | | 2. electrical consumers (radio, light) should be turned off. | | 3. Connect the tachometer. | | 4. Allow the engine 2-3 times greater momentum and leave to idle. | | 5. Cock a manual brake. | | 6. Check the idle speed. |  | 7. If the idle speed is not installed correctly, loosen the lock nut and adjust the number of revolutions of the rotation of the adjusting screw (1). After adjustment Tighten the screw. |
A warning  Do not turn the other screws.
|
|
Check / adjust the maximum speed
| PERFORMANCE ORDER | | 1. Check the adjustment of the drive gas. | | 2. Fully depress the accelerator pedal and check the maximum speed. | | 3. If the maximum speed is not installed correctly, loosen the lock nut and adjust the number of turns, rotating the adjusting screw. After adjustment Tighten the screw and install the new seal. |
A warning Do not turn the other screws.
| | 4. Disconnect the tachometer. |
|
Adjusting damper
| PERFORMANCE ORDER | | 1. Start the engine and warm up until the temperature gauge coolant reaches the middle of the scale. | | 2. Connect the tachometer. | | 3. Uvelichitte with a lever RPM and slowly release until the adjusting screw touches the damper. The number of revolutions should be at the same time in 1300 rev / min. | | 4. If necessary, the required number of turns with the screw. |
|
|
