REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Terrano II (from 1985 to 1999 model year)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Nissan
	Terrano 2
		Operation and Maintenance
		Maintenance Vehicle
		The four-cylinder engine
		Engines VS
		All engines
		Systems of cooling, heating, ventilation and air conditioning
		Fuel and an exhaust system
		The system of electric motor
		Emission of exhaust gases
		Manual transmission
		Automatic Transmission
		Coupling the propeller shaft and rear axle
		Chassis car with wheel formula 4x4
		Brakes
		Suspension and steering
			Technical data
			Overview
			Wheel studs - Replacement
			Stabilizer - removal and installation
			Shock absorbers - removal and installation
			Torsion - removal and installation
			Bars and streamers suspension - Removal and installation
			The upper arm and ball joint and install -snyatie
			The lower arm and ball joint and install -snyatie
			Spring rear suspension - Removal and installation
			Rods rear suspension - Removal
			Stabilizer rear axle - Removal and installation
			Steering - general information
			Steering wheel - removal and installation
			Steering lock -snyatie and installation
			Steering gear - removal and installation
			Steering gear (a / m without power steering) - dismantling
			Steering
			Power-steering pump and installation -snyatie
			Removal of air from hydraulic drive wheel
			Steering Linkage - removal and installation
			The front axle -General information
			Wheels and tires - general information
		Body and trims
		Electrical system

Rods rear suspension - Removal

Attention!

Take each post individually (except for the removal of the rear axle).

1. Raise the rear of the vehicle and axle stands under the frame.

2. Lift the rear axle jack is matched under the gear case.

3. Remove the lug nut bars, beat out bolts and remove the rod.

4. Installation is carried out in reverse order. Nuts bars definitively tighten after car lowering the wheels.