printable version
The lower arm and ball joint and install -snyatie
1. Lift the front of the vehicle. 2. Remove the wheel. 3. Remove the torsion bar. 4. Disconnect the lower arm shock. 5. Disconnect the lower arm stabilizer. 6. Release the lower ball joint nut. Extract the stripper finger from the lower support lugs fist (photo). On all-wheel drive cars need Toggle remover (such as "scissors") .. 7. Disconnect the lower arm bar. 8. Remove the axle nut and remove the lever shaft (see photo). 9. Remove the movable arm torsion and pull them lever suspension. 10. Turn away bolts and remove a support. Support not folding, and if worn replaced entirely. 11. If you want to beat out of the sleeve frame. 12. Installation is performed in reverse order. Nuts support and the axis of the lever, tighten with the set moment. After lower the car and check the amplitude of the swing arm (dimension H, see. Above). Check and adjust the wheel alignment.
|