printable version
Steering Linkage - removal and installation
1. steering tie rods are thrust side, lateral thrust, fry and idler arm (photo). 2. All the tie rods can be removed in gathering with the swing arm and fry. After removing the rods, check the wheel alignment. Finally tighten the lugs nuts after lowering the vehicle. Side traction 3. Rasshplintuyte and unscrew the nuts (photo).
| 20.3 Details of the lateral thrust 1. The outer tip 2. Clamp 3. Screw the sleeve 4. The inner tip |
4. Extract the tips of his fingers thrust pliers (photo) and remove the rod. 5. Check the play in the ball stud, if necessary, replace the fingers. 6. If necessary, disassemble the rods, which mark the position of the tip in the sleeve, remove the clamp bolts and remove both of the tip. 7. Assembly and installation are carried out in reverse order. If set to remove a tip, then combine the labels put before dismantling. If you install a new thrust, then set the size of A shot drafts (photo). After assembly, check and adjust wheel alignment.
| 20.9 Details of the idler arm 1. Case 2. Bracket 3.6. Sleeve 4.Mzyatnikovy lever 5. Plug nipples 7. Washer 8. Nut |
| 20.4 pressing off the tip of the finger |
| Size 20.7 A, which is necessary to put on new rods |
| 21.1 front axle 1. Vertical 2. A line parallel to the axis of symmetry of the vehicle 3.Razval 4. axle suspension ball joints 5. The longitudinal angle of inclination of the axis of rotation 6. Toe |
Swingarm 8. Play in the idler arm eliminates installing new plugs. 9. Remove the bolts of the lever arm to the frame (see photo). 10. Rasshplintuyte and unscrew the nut, press out the idler arm finger of transverse rod (photo). 11. If you need to replace the hub, then unscrew the nut, remove the washer and remove the lever arm, remove the bushing. Replace bushings and assemble the lever. 12. Installation is performed in reverse order. Tighten all screws to the specified torque. Cross Rod 13. Rasshplintuyte and remove all nuts of the transverse rod. 14. Extract the fingers and remove the rod. 15. Check the condition of thrust bushings and replace if necessary. 16. Installation is performed in reverse order. Traction steering assembly 17. Remove the nut fry and fry Xpress from the shaft of the gearbox. 18. Remove the bolt and idler arm. 19. Rasshplintuyte and unscrew the nuts of the side rods to the knuckle, press out the fingers. 20. Remove any traction. 21. Installation is performed in reverse order
|