printable version
Stabilizer - removal and installation
1. Lift the front of the vehicle. 2. Remove the dirt scraper.
| 1.2 Details of the front axle wheel drive cars 1. Washer 2. Bushing 3. axle nut. 4.6. 5. Washer sleeves 7,10,17,27. 8. Cover the fixed arm torsion bar 9. Locking ring 11. The heel 12. Torsion 13. Bolt 14. The movable arm torsion bar 15. Shock |
3. Remove the nuts of the stabilizer rod (photo). 4. Remove the thrust, marking the turning sleeve and washers. 5. Remove the screws and remove the stabilizer (photo). 6. If necessary, remove from the stabilizer bushings. 7. Check the linkage bushings and replace if necessary. 8. Installation is performed in reverse order. Install the regulator so that the white label near the bushes could be seen from both sides of the car. Details of the stabilizer rods set in the same order. Finally tighten the bolts after lowering the vehicle.
|