add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Terrano II (from 1985 to 1999 model year)

general info. full specifications. diagnostics. hints. tips. tricks
Nissan Terrano 2
Home
 
Nissan
Terrano 2
Operation and Maintenance
Maintenance Vehicle
The four-cylinder engine
Engines VS
All engines
Systems of cooling, heating, ventilation and air conditioning
Fuel and an exhaust system
The system of electric motor
Emission of exhaust gases
Manual transmission
Automatic Transmission
Coupling the propeller shaft and rear axle
Chassis car with wheel formula 4x4
Brakes
Suspension and steering
Technical data
Overview
Wheel studs - Replacement
Stabilizer - removal and installation
Shock absorbers - removal and installation
Torsion - removal and installation
Bars and streamers suspension - Removal and installation
The upper arm and ball joint and install -snyatie
The lower arm and ball joint and install -snyatie
Spring rear suspension - Removal and installation
Rods rear suspension - Removal
Stabilizer rear axle - Removal and installation
Steering - general information
Steering wheel - removal and installation
Steering lock -snyatie and installation
Steering gear - removal and installation
Steering gear (a / m without power steering) - dismantling
Steering
Power-steering pump and installation -snyatie
Removal of air from hydraulic drive wheel
Steering Linkage - removal and installation
The front axle -General information
Wheels and tires - general information
Body and trims
Electrical system
 


Hit Counter by Digits


print page printable version

Steering lock -snyatie and installation



1. Prepare the mounting screws shear lock (available only in the service station Nissan).
2. Remove the wheel.
3. Remove the column cover.
4. Carefully drill out the two shear screws, picking up the drill core diameter of the screw.

15.1 In order to access to the gear necessary to shine rubber apron
15.1 In order to access to the gear necessary to shine rubber apron


15.2 Screw the bottom hinge (car drousilitelem GIS)
15.2 Screw the bottom hinge (car drousilitelem GIS)


15.3 Removing the pitman arm from the shaft gear 1. Gear housing 2. bipod
15.3 Removing the pitman arm from the shaft gear 1. Gear housing 2. bipod


15.5 bolts steering gear is located inside the sill of the left side member of the frame
15.5 bolts steering gear is located inside the sill of the left side member of the frame


5. Remove the two screws and remove the extra lock. Disconnect the wires.
6. When installing, align the holes and tighten the screws. Check by inserting the key operation lock and tighten the screws.
7. Tighten the screws to shear breaking of heads (see photo).
8. The rest of the assembly is done in reverse order.




« previos page
Steering wheel - removal and installation
next page »
Steering gear - removal and installation

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.