printable version
Steering gear - removal and installation
1. Remove the left front wheel. To gain access to the gearbox, remove the rubber flap from the engine compartment (see photo). 2. Remove the bolt of the hinge to the reducer (photo). 3. Remove the nut and remove the bipod bipod (photo). 4. On cars with power steering, unscrew the nozzle and plug the pipes and drain the hydraulic drive. 5. Turn away bolts and remove gear (see photo).
| 16.2 Details of the steering gear 1.10. Lock-nut 2.6 Gland 3.Regulirovochnaya nut 4. Ball nut and drive shaft gearbox 5. Spring washer 7. Housing 8. Shaft bipod 9. The adjusting screw 11. Stopper 12. Cover 13. Gasket 14. Rego |
| 16.5 Unscrewing adjusting nut gear |
6. Installation is a reverse order. Before wrapping the lower hinge bolt set the wheels in driving position on a straight line, check the position of the steering wheel. The groove in the shaft must be aligned with the bolt holes in the elastic coupling. Tighten all bolts to the specified torque. When installing, check the bipod bipod match splines and shaft. Tighten the nut with the set moment. On vehicles with hydraulic fill with fluid and remove air.
|