REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Golf IV (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Golf 4
		Instructions
		Engine
		Cooling system
		Fuel System
		Exhaust system
		Ventilation and heating system
		Coupling
		Transmission
		Suspension brackets and power shafts
		Steering
		Wheels and tires
		Brakes
			Technical specifications
			ABS / EBV / EDS / ASR / MSR
			Replacing the front brake pads on support FS-III
			Replacing brake pads on a support FN-3
			Replacing the rear brake pads on disc brakes
			Brake disk
			Adjusting handbrake
			Replacing the rear brake pads Drum brakes
			Removing and installing rear working brake cylinder
			Bleeding the hydraulic brake system
				Bleeding - the basic method (two persons)
				Bleeding - using set with the unidirectional valve
				Bleeding - using a set of squeezing
				All methods
			Brake pipelines and hoses
			Check the brake servo
			Removal, installation and adjustment of brake light switch
			Removal and installation of cables of a manual brake
			Key brake failure
		Body
		Electrical equipment and wiring

printable version

All methods

PERFORMANCE ORDER

1. After completion of the pumping press firmly on the brake pedal, thus it should pass about half of course.

2. Rinse off all traces of spilled brake liquid also tighten unions pumping demanded moment, then establish on them dustproof caps.

3. Check the fluid level in the brake system popolnitelnom tank and, if necessary, top up the brake fluid.

4. Remote brake fluid should not be used anymore. Pure brake fluid must be kept in a sealed vessel, since it is highly hygroscopic, which lowers the boiling point and deteriorates specifications brake fluid.

« previos page
Bleeding - using a set of squeezing

next page »
Brake pipelines and hoses