| Home |
| | | Kia |  | Sportage | | Introduction | | Controls and operation receptions | | Current care and maintenance | | Engine | | System of cooling, heating, ventilation and air conditioning | | The power supply system, motor control / emission control and exhaust | | Systems of an electric motor | | A five-speed manual gearbox gear | | Automatic Transmission | | Transmission Line | | Brakes | | Suspension and steering | | Body | | Onboard electric | | General information and precautions | | Search of causes of failures of electrical equipment | | Safety locks - the general information | | Circuit breakers - the general information | | Relay - the general information and check of serviceability of functioning | | Mounting fuse / relay box - general information, removal, installation, replacement of fuses | | The system timer and alarm gongs (ETWIS) - general information, removal and installation of the control module | | Check of serviceability of functioning of the ignition switch | | Check of serviceability of functioning of the steering column switch | | Check of serviceability of functioning of the control switches and electric drive windows | | Check of serviceability of functioning of the control switch and electric adjustment door mirrors | | Cabin lighting - lamp replacement, check of serviceability of functioning | | Replacement lamps and check of serviceability of functioning of external lighting | | Removal, check of serviceability of functioning and installation of the flasher / alarm | | Removal, installation and adjustment of the headlight units | | Airbags - general information and precautions | | Disable SRS | | Read the DTC code | | Removing and installing driver's airbag module | | Removal, installation and adjustment of the contact cable reel driver airbag module | |  | Removing and installing airbag diagnostic module (ADU) | | The control body dimensions | |  | Wiring | | | |
|
|
|
 printable version
Removal, installation and adjustment of the contact cable reel driver airbag module
 | Combined pin electrical cable reel is not subject to dismantling and individually does not change. |
Refitting
| - Details of the cable drum shown in the illustration details the installation of the module driver's frontal airbag.
- Install the front wheels in the straight-ahead position.
- Make sure that the front wheels are shown in the straight-ahead position.
- Remove the module driver's front airbag (see. Section Removal and installation of a driver's airbag module).
- Loosen the nut on the steering wheel.
- Mark the position of the wheels relative to the steering shaft.
- Using a special puller remove the steering wheel.
- Remove the three screws and remove the pin cable drum, together with combined steering column switch.
- Installation is in the reverse order - before final installation of the steering wheel and airbag module do not forget to adjust the cable drum.
|
|
Adjustment | When adjusting the cable drum track uses a special pin that comes with a new gearshift paddles - when installing the original switch is necessary to prepare the replacement of the adjusting pin. |
| - Temporarily install the steering wheel and bring the front wheels in the straight-ahead position. Remove the wheel.
- Until it stops, expand the cable reel clockwise.
 | - Return the drum back on turnover of 2.75 - arrow signs on the plate of the drum and the housing must be aligned.
|
- Install the steering wheel, - track correctness of combination caused during the dismantling of the landing labels.
|
|
|
|
