printable version
Chain tensioner
Arise when working circuit noise can be caused by deficiencies in the functioning of the tensioner. Dismantle and check. If necessary, replace the tensioner complete.
| Chain tensioner (244) is screwed on the right side in the cylinder head. Through the hole in the cylinder head in the chain tensioner is supplied under engine oil pressure. |
The chain is tensioned by the force of the compression spring (230) and the oil pressure in the tensioner. The contact pressure of the finger (233) to the control bus (215) is kept constant by means of a check valve (227/228) and the pressure limiting valve (227/231), t. E. Independent of engine oil pressure.
Withdrawal PERFORMANCE ORDER | Remove chain tensioner for hexagonal head (235) of the cylinder head. |
|
Control
PERFORMANCE ORDER | 1. Place the chain tensioner with a pressure finger in engine oil SAE 10. The oil level should be slightly above the rim hex tensioner. 7-10 Push the push finger press. | 2. After filling the oil tensioner must be compressed slowly, gradually and with great power effort. Otherwise, replace it. |
|
Setting A warning Install chain tensioner only in the oil-filled state.
PERFORMANCE ORDER | | Install chain tensioner with a new gasket and tighten the bolts to a torque of 80 Nm This finger pressure must be adjacent to the ledge slide tension. |
|
|