 | 1. To lift the hood, pull in the direction of the arrow locking lever (3) on the left and slightly raise the hood to avoid locking of the locking lever. Disconnect the right locking lever and install the bonnet vertically. |
A warning  Left locking lever must enter into the upper retainer.
|
2. Unplug the power supply (-) from the battery.
A warning This erased anti-theft radio code. Before disconnecting the battery should read the instructions in the section on removing and installing the battery.
|
 | 3. Disconnect the air hose (arrow) from the air filter and diffuser, turning slightly at the same hose and squeezing his length. |
| 4. Remove the air filter. |
 | 5. Remove the crossmember (1) with the spacer (2) (arrow). |
| 6. Remove the thrust of the engine hood. |
| 7. Remove the throttle cable and set aside. |
8. Disconnect the electric wires from the body to the engine, preliminary having marked them with adhesive tape. For example:
- Remove the plug with a thermal switch;
- Loosen the fastening of wires glow plugs (key size 10 mm) and remove it from the holder;
A warning In some models, fixing nut, not to lose, are inserted into the cable lug.
- Air conditioning: electrically disconnect from the air conditioning compressor. |
| 9. Disconnect and remove the electrical wiring from the holders. |
10. Disconnect all hoses vacuum that come from the body to the engine compartment. For example:
- Unscrew the hose to the vacuum brake booster vacuum pump. |
| 11. Remove the fuel pre-mark them with tape to facilitate subsequent installation. Speaking fuel blot cloth. |
| 12. Raise the vehicle. |
| 13. Remove the bottom cover of the engine compartment. |
 | 14. Disconnect the positive cable (X4) of the contact element on the underside of the car on the left and put the top of the engine. |
| 15. Remove the outlet flange of the exhaust pipe from the exhaust manifold. |
| 16. Drain the coolant. |
17. Remove the heat sink.
A warning For vehicles with air conditioning immediately after the radiator install the condenser guard.
|
| 18. Remove all coolant hoses between the engine and the body, after loosening and completely throwing fixing clamps. |
 | 19. Remove the plug of the oil pressure switch (43) and the oil level sensor (44). |
| 20. Disconnect electric wire (45) from the starter. |
| 21. Release the harness (46) from the holder. |
| 22. Remove shtekkernoe connection to the three-phase generator. |
