printable version
Approximate adjustment of headlights
For precise adjustment of headlights requires a special measuring device, so you should entrust the job workshop. A similar service is offered as some filling complexes. Check and adjust their own headlights. Preparing Your Car for a rough adjustment of headlights 1. The fuel tank should be full. Otherwise, place the ballast in the trunk (in half-filled tank - 30 kg). 2. Behind the wheel should be an assistant (otherwise use the ballast weight of 75 kg). 3. Tyre pressure should correspond to the norm.
| Fig. 9.22. Adjusting beam headlights
|
4. Put the vehicle in front of the wall. The distance from the wall to the vehicle must be exactly 5 meters (Fig. 9.22).
1. Measure the distance from the floor to the center point of both headlamps. Value aside on the wall and draw a line S1. 2. In five centimeters beneath perform on the wall parallel to the line e. This deflection beam at a distance of 5 m. 3. Looking through the rear window forward and ask the assistant to the exact center of the vehicle to hold the vertical line M. 4. Measure (left and right), the distance between the center of the vehicle and the center point of the range. These values are set aside on the auxiliary line S1 (left and right of the point of intersection of the lines M and S1) and mark the mounting cross S2. 5. Just 5 cm beneath these crosses should be when adjusting break points on the adjustment beam line E. 6. If the vehicle is equipped with fog lamps, for their regulation should be on a similar principle to hold auxiliary line with the installation of the cross (the central point of the fog lights).
|