printable version
Replacing the bulbs in the headlights
All incandescent light bulbs in the headlamps fitted to the engine compartment. Before replacing the lamp, make sure that the relevant consumer is switched off. Replacing the parking light bulbs does not violate the adjustment range. After replacing all the other lamps must be checked (in the workshop) setting the appropriate lights. When replacing the lamp, do not touch the flask hands: even the slightest traces evaporate on a hot lamp and this results in a clouding of the reflector. Therefore, when replacing the lamp with a clean cloth.
| Fig. 9.19. The reverse side lights when the cover is removed. For greater clarity, the headlamp is removed from the car: 1 - dipped; 2 - the main beam; 3 - dimensional light; 4 - turn indicator; 5 - gear lights corrector
|
1. Depending on the design of the cover, turn the lights dipped beam or anti-clockwise to remove it and remove the cover from the rear of the respective lamps, pre unfasten the retaining clamps (Fig. 9.19). If the vehicle is fitted with headlight washers, remove the pre-washer fluid from the reservoir next to the left headlight. 2. Middle and high beam. Remove the connector from the bulb. 3. Pull the wire bracket that holds the lamp and pull the lamp itself. 4. If you are installing a new lamp, note that its base was a hole reflector. 5. Position / parking lamps. Remove the cartridge with the lamp. Remove the bulb from the socket and replace. Install the cartridge into place.
|