printable version
Checking the audio signal
1. Connect the signal wires to the terminals of sufficient length, the other ends of which are attached to the positive and negative terminals of the battery. 2. If there is no signal, it is defective. 3. If the alarm sounds, but when installed did not sound, the problem should be sought in the circuit (fuse, push button). 4. hoarse or muffled sound signal can be adjusted by turning the adjustment screw on the back side of the body signal.
| Fig. 9.33. Removal of sealant adjusting screw beep
|
5. To do this, first remove the sealant from the screw (arrow) (Fig. 9.33). 6. After the adjustment screw on the back, apply sealant to prevent moisture penetration.
|