 printable version
Removing and installing sump
To seal sump conventional sealant is used, for example, Loctite.
A warning  Do not apply too much sealant, be especially careful near the bolt holes. Details are to be assembled together for 5 minutes after sealant application. After this time the sealant must be removed and re-applied.
Withdrawal
| PERFORMANCE ORDER | | 1. Disconnect the earth cable from the battery. |
A warning This electronic memory is erased, for example, the storage engine fault code or radio. Before disconnecting the battery should read
notes in Section 7.2.
| | 2. Lift the car. | | 3. Remove engine underbody protection. | | 4. Drain the engine oil. | | 5. Remove the center beam. | | 6. Remove the front exhaust pipe. | | 7. Remove the sump bolts. |  | 8. Drive a wedge into the seal between the cylinder block and the pallet (arrows indicate the location of the seals). In the workshops for this tool is used KV-10111100, which is driven between the cylinder block and oil pan. | | 9. If the device is not present, you can use an old knife. Carefully drive in the knife with a hammer between the unit and the tray. |
A warning In no case did not pan poddevat screwdriver or chisel, not cutting the pre-seal. When lifting, make sure that was not damaged uplotnitlnaya surface of the oil pan.
| | 10. Remove the oil pan. | | 11. It is recommended that if you remove the tray remove the strainer and clean the filter it in a cold cleaner. | | 12. Check the grid damage, such as tears and replace if necessary. |
|
Setting
|
