1. Remove the cylinder head cover. |
| 2. Set the first cylinder in the ignition TDC. To do this, move the transmission to idle and turn the crankshaft clockwise with a star attached central bolt pulley on the crankshaft. Rotate the crankshaft until the mark is "ON" on the belt pulley will not be under the pointer (arrow). |
A warning Do not turn the engine back. In no case did not turn the shaft of the bolt of the distributor gear.
|
| 3. In this position, insert the locking pin or other suitable rod with a diameter of 6.75 mm into the opening of the intake camshaft gear (2) through the cover of the first camshaft bearing or rotate the crankshaft one full turn and insert the pin. |
4. Mark the position with respect to each other's distribution gear and control circuit with the help of polish or graver, pre-wiping cloth is a place on the gear chain. |
5. Remove the chain tensioner. |
6. Unscrew the bolts and remove the exhaust camshaft gear. To loosen the bolts need a key with the end nozzle size T40. A warning The control circuit must remain in engagement with the pinions of the crankshaft and a fuel pump. Otherwise, change the valve timing, which may cause malfunction in the engine.
|
7. Put the control circuit to the side and attach the wire to the cylinder head. |
8. Number the order of the camshaft bearing caps to the subsequent installation to install them to their original location. |
9. The 2.5-liter engine: Unscrew the camshaft bearing caps. A warning The camshafts are very fragile. To avoid damaging them, strictly observe the sequence of disassembly, first loosen all of the bolts bearing 1, 3, 4 and 6 (arrows). Then loosen the screws alternately on both bearing caps 2 and 5 (respectively 1/2 turn) until there is no opposition (see. Fig. Bolts camshafts).
|
10. The engine capacity of 2.2 liters: first unscrew the bearing caps 1, 3 and 5. Then gradually loosen the bolts bearing caps 2 and 4 (or 1/2 turn) until there is no resistance. |
11. If necessary, remove the bucket tappets and check for external damage (scratches), replace if necessary. For pulling the pusher used in the workshop siphon ejector which in the home can be made of the sucker wall hook. |