REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz E-Class

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	E-class
		Introduction
		Description of the model Mercedes E-Class
		Working conditions and tools
		Car Care
		Diesel engines
		Petrol engines
		Transmission
		Chassis
		The brake system
		Electrical
			Accumulator battery
			Starter
			Generator
			Checking the level of electrolyte in the battery, service contacts.
			Checking the battery charge
			Start the engine from the external power supply
			Charging the battery
			Removing the battery
			Detection of faulty consumer
			Checking the voltage regulator
			Removing the generator
			Removing and installing starter
			Lighting
				Permanent monitoring of the lighting device
				Replacing the bulbs in the headlights
				Replacing the lamp fog lamp
				Removing the headlamp
				Approximate adjustment of headlights
				Adjusting headlamp
				Adjusting fog lamps
				Replacing the lamp in the rear lamp
				Removing the rear light
				Replacing the lamp is an additional signal of braking
				Changing the light bulb license plate
			Sound and light alarm
			Control equipment
			Device combination
			Cruise control (cruise control)
			The system of airbags and seat belt pretensioners
			Wires and fuses
			Cable colors
			Mounting block relays and fuses
			Circuit breakers
			Electrical circuits
		Shop
		Body
		Applications
		Diagrams

printable version

Changing the light bulb license plate

SEQUENCE OF WORK

1. On the sedan, unscrew the four bolts and remove the lid handle.

Fig. 9.28. To replace the lamp assembly as defined license plate light on the sedan is first necessary to unscrew the handle of the boot lid

Fig. 9.29. At the T-model, each lantern lighting is fixed with two bolts (arrows) in the case of a back door

2. Carefully remove the screwdriver from niche lights (Fig. 9.28). The T-models unscrew the two screws on each lamp and pull out the back door of the holes (Fig. 9.29).

3. Remove the bulb from the soffit spring contacts, if necessary, slightly bend the spring contacts.

4. Install the new lamp.

« previos page
Replacing the lamp is an additional signal of braking

next page »
Sound and light alarm