| The correct functioning of VSS can be checked on the adequacy of the speedometer. |
1. Remove the VSS with the transmission housing. | 2. Connect a voltmeter to the two terminals of the sensor and switch the meter to AC voltage measurement. Start manually rotate the drive gear sensor - voltmeter should register a signal amplitude of approximately 0.5 V. |
3. In the absence of the signal voltage sensor must be replaced. 4. If the positive results of the above test, check for open wiring on the circuit between the connector and VSS dash (see. The wiring diagram at the end of the Head the Onboard electric equipment). If the wiring in the order, drive to a workshop to diagnose the PCM and perform the proper reconditioning. |