1. Disconnect the negative wire from the battery. | If installed on the car stereo is equipped with a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action! |
| 2. Remove the two screws that secure the bottom edge of the panel of an internal upholstery. |
| 3. Gently prying with a screwdriver under the front edge of the armrest release the control panel operation of the electric window, disconnect from the extracted wiring panel. |
| 4. Remove the inside door handle trim. |
| 5. Remove the retaining screw located in the pocket gripper arm armrest. |
| 6. Pulling the panel of an internal upholstery of doors, disunite contact sockets passing underneath wiring. |
| 7. With the aim of providing access to the inside of the door frame, remove the protective insulating screen - try not to damage the film. Do not forget to return the screen in place before installing upholstery panel. If necessary, an additional use for the fastening of the film sealant. |
8. Make sure in good condition and the presence in place of regular panel retainers inner door trim. 9. Restore initial connection of electrical wiring and install trim panel on the door. snap fasteners and tighten the screws. Replace the control panel operation of the electric windows. |