1. Adjusting the hood in the engine compartment opening is made by moving to the appropriate side of the hinge brackets after the weakening of fasteners. | If the factory mounting brackets used for self-centering screws, do not allow the possibility of such a regulation, such fasteners should be replaced by a standard-type bolts, do not forget to equip them with flat and lock washers. |
2. In order to control the displacement circle looped strap marker. 3. Loosen the fasteners and hinges, slide in the desired direction (make adjustments slowly, in stages, slightly shifting the strap loops for each approach). Re-tighten the bolts, lower the hood and check the correctness of his position in the doorway. | 4. If necessary, adjustments can be made position of the latch assembly of the bonnet to the radiator support plate (vertical and horizontal) - the hood should be closed tightly and down flush with the wing surface. To adjust the castle circle head bolts assembly latches marker or prescriber, then loosen the screws and slide the latch in the desired direction. After adjusting tighten the mounting bolts. |
| 5. Finally, adjust the position of the rubber pads on the hood panel radiator support, ensuring that the hood in the closed position are flush with the wing surface. |
6. Assembling the hood latch of the lock should be periodically (at the same time loops - see. Section Service hinges and locks the car) lubricated with lithium based grease to prevent sticking and premature wear. |