Removal and installation of the latch cylinder lock and door handles

1. Remove the screws that secure the latch to the door. Insert your hand through the process opening into the door frame and detach the latch actuating rods.

2. On models equipped with single lock, disconnect the corresponding wiring.
3. Remove the latch and, at the appropriate equipment, electromagnetic activator lock.
4. Install in the reverse order.

1. Remove the stem from the executive outside door handle, give fixing nuts and remove the handle from the door panel.

2. Disconnect the wiring on the door lock activator. With the help of pliers, release the retaining clip and remove the door lock cylinder.
3. Install in the reverse order.

1. Remove the interior door trim (see. Section Removal and installation of panels of an internal upholstery of doors).

2 .Vyvernite fixing screws, release the assembly of the internal handle of the door frame and remove the rod from her executive (s). Remove the handle.

3. Install in the reverse order.