REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Maxima QX (1993 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Nissan
	Maxima QX
		Introduction
		Operating Instructions
		Adjustment and routine maintenance
		Engine
		System of cooling, heating
		The power supply system and release
		Electric motor
		Engine Control Systems
		Transmission
		Coupling and power shafts
		Brakes
		Suspension and steering
		Body
			General information and precautions
			Caring for the components of the body and underbody
			Care of vinyl trim elements
			Care of an upholstery and carpets salon
			Repair minor damage to body panels
			Repair severely damaged body panels
			Service loops and locks the car
			Replacing the windscreen and other fixed windows
			Removal and installation of decorative grille
			Removal, installation and adjustment of position of a cowl
			Removing and installing bonnet latch and its actuating cable
			Removal and installation of front and rear bumpers
			Removing and installing the front wings
			Removing and installing the front panel of the reflector
			Removal and installation of panels of an internal upholstery of doors
			Removal, installation and adjustment of doors
			Removal and installation of the latch cylinder lock and door handles
			Removing and installing door glass
			Removing and installing electric window regulators
			Removal and installation of rear-view mirrors
			Removal, installation and adjustment of the luggage compartment lid
			Removal and installation of latches and lock cylinder cover luggage
			Removal and installation of power cables release locks luggage compartment lid and access door fuel filler
			Removing and installing center console
			Removal and installation of finishing sections dashboard
			Removal and installation sections of the column cover
			Removal and installation of the main section of the instrument panel
			Removal and installation of seat
			Removing and installing rear shelf
			Adjusting the top hatch
			Body sizes
		Onboard electric

printable version

Removing and installing bonnet latch and its actuating cable

Considered in this manual car models are equipped with additional safety (SRS). Before proceeding with any work near the airbag unit, steering column and instrument panel, disconnect SRS to avoid injury at its casual operation (see chap. Onboard electric equipment). Wiring of chain SRS is easy for distinguishing on yellow color of isolation.

If installed on the car stereo is equipped with a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action!

Latch

PERFORMANCE ORDER

1. Circle the latch assembly marker or prescriber to guarantee the correctness of its installation in the assembly. Unhook the spring and use a screwdriver to release the tip of a cable lock is released from the latch assembly.

2. Install in the reverse order.
Adjust the latch so as to lock the hood securely in the closed position, - rubber pillows of support should be slightly flattened.

Bowden cable

PERFORMANCE ORDER

1. Disconnect the drive cable is released from the bonnet latch assembly.

2. In the passenger compartment, remove the three fixing screws and separate from the instrument panel bonnet release lever. Disconnect the cable from the lever.

3. Pull the cable assembly to the salon, gently pushing it through the grommet in the bulkhead.
4. Insert the tip of the new cable in the grommet in the bulkhead and retract assembly in the engine compartment of the wire through the bulkhead in the engine compartment, having held up his end of the bonnet latch.
5. The further assemblage is made in the reverse order of removal.

« previos page
Removal, installation and adjustment of position of a cowl

next page »
Removal and installation of front and rear bumpers