REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Golf IV (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Golf 4
		Instructions
			eleven Controls, devices and equipment
			Weekly checks and service in a way
			Maintenance
				Technical specifications
				Frequency of service
				Schedule maintenance
				Motor oil
				Changing the oil and oil filter
				Exhaust system check
				Engine cooling system
				Replacing the air filter element
				Checking the V-ribbed belt
				Spark plug
				Replacement of the fuel filter (diesel engines)
				Check of tightness of hoses and fluid leakage
				Belts
				Measurement of deterioration of gear belts on diesel engines
				Transmission / final drive
				Check the front suspension and steering
				Checking the shock absorber
				Check the radiator
				Check the wiring
				Checking the liquid level in the steering amplifier
				brake fluid
				Checking the front brake pads
				Checking the rear brake pads of disc brakes
				Checking the rear brake pads drum brake
				Check of brake hoses
				Check of cables of a manual brake
				Checking the condition of seat belts
				Airbags
				Door Hinge
				Replacement of the dust filter
				Accumulator battery
					Check the electrolyte level
					Operation in winter conditions
					Battery charge
					Removing the battery from the electrical system
					Removing and installing the battery
					The acquisition of the battery
				Washers
				Wiper
				Check the initial position of the wiper arm
				Replacing the batteries in the remote control key
				Resetting Service-indicator
		Engine
		Cooling system
		Fuel System
		Exhaust system
		Ventilation and heating system
		Coupling
		Transmission
		Suspension brackets and power shafts
		Steering
		Wheels and tires
		Brakes
		Body
		Electrical equipment and wiring

printable version

Removing and installing the battery

Withdrawal

PERFORMANCE ORDER

1. Before removing the battery switch off the ignition and turn off all power consumers.
	2. Squeeze the two sides of the fuse holder cover and tilt it to the side.
3. Unscrew and remove the battery negative lead (1) (see. Fig. Location of the fuses on the battery).
4. Loosen the positive wire.
5. Fold the front first and then the rear clamp from the battery terminal. To do this, squeeze out a few clips from the battery.
6. Remove the fuse holder up with the positive wire from the battery.
7. Remove the screw that secures the battery and remove it from the vehicle.

Setting

PERFORMANCE ORDER

1. When installing the batteries must see to it that the ignition and all current consumers are switched off.

2. Insert the battery in the designated place for it and secure it with a bolt. At the same time, make sure that the battery mounting sock coincided with an approved recess.

3. Pull the fuse holder in place, together with the positive wire on the battery until it locks clips on the longer side of the battery.

4. Tighten the nut on the positive wires.

5. Connect the negative battery cable.

6. Replace the fuse holder cover and secure the two spring clips.

« previos page
Removing the battery from the electrical system

next page »
The acquisition of the battery